After searching through my part bins, I was able to find a contact that I fitted into the connector for the battery pack, to replace the contact that was corroded. I fitted some spacers between each of the cell, then wrapped the battery pack in some tape to seal it.
Once the pack was assembled, it was fitted back into the HX-20. While reassembling the computer, I spotted a dry joint on the DC jack. So once again I disassembled the computer to remove the main PCB.
Once the PCB was out, I removed the DC jack, cleaned the contact for the DC jack, cleaned the pads on the PCB, reassembled the computer and tested it. The computer beeped when it was powered on, but I got no text on the LCD. So scratching my head, I disassembled the computer and checked the connectors. They all looked good. Then I remembered that the computer may need to be reset, as the battery had been out of the laptop for a few days.
So while the LCD was not showing anything when powered on, I remembered that you need to press “CTRL & @” to initialise the computer. After entering in a dummy date time of “01010101101” and pressing “Enter”, the computer reset and the LCD became active.
Yeah, the battery has been replaced and the computer is working again. 👍